B2B Portal for Technical and Commercial Foundry Management
Languages
Foundry Daily News

GER - Magnets hold dies securely, allow rapid changeover

Clamping and changing systems based on electric permanent magnets enable moulders to save costs and setup time and enhance safety.

Magnetic clamping and changing systems can help moulding, metalworking and die-casting companies save costs, reduce setup times, enhance productivity and safety, and improve production quality. Their value is seem especially in small-series manufacturing. A diverse range of Hilma-brand magnetic clamping plates from the Römheld Group are available to answer growing demand for this flexible quick-tool-change technology.

Saving time and ensuring safety during setup are the most common reasons for using magnetic clamping systems, according to Römheld. Even dies as hot as 240°C and large moulds weighing several tons can be changed and prepared for production in less than 30 minutes by one operator using a simple, quick die-changing system consisting of magnetic clamping plates, a die cart and roller bars.
Size doesn’t matter

By means of magnetic clamping plates, dies and tools of any size and shape can be positioned and clamped. Both the expensive standardisation of dies and tools and the need to use various clamping devices can be avoided. The technology thus enhances the scope of application and productivity for companies coping with small batch sizes, a growing variety of formed parts and short deadlines.

Magnetic clamping is based on the principle of the electric permanent magnet, which ensures absolute safety in the event of power failure. An electrical pulse magnetises the system for 2 seconds or so, which clamps the die onto the plates at a force of 3,000 kN or more. Even mould halves weighing several tons are held reliably and without deformation, true to position and in parallel. The magnetic field penetrates only a few millimetres into the die. During production, the permanent magnets—independent from the electrical power supply—keep the plates securely in position. Electrical power is then required only to unclamp the plates and release the die.


Sourced from etmm-online.com

Youtube Linkedin Xing